Universal Remote MX-890 Owner's Manual download pdf (Page 6)

MX-890 COLOR LCD SCREEN

Connecting the Battery Pack

Unlock the rear cover by pressing down on the spring lock at the

top of the cover. Remove the cover. For shipment from the factory,

the battery is left out of the MX-890. Place the battery into the

battery compartment, making sure you align the contacts on the

battery to the contacts on the MX-890. The battery will snap into

place when aligned properly. Replace the cover and snap it into

place.

Using the Charging Base

Plug the 5V adapter into a power outlet and into

the back of the charging base.

Gently place the MX-890 into the cradle of the

charging base. It automatically aligns itself

to the contacts on the charging base.

The Status light should immediately light. Red

indicates that it is charging. Blue shows that it

is fully charged. There is no harm in leaving

the MX-890 on its charging base whenever

it is not in use.

Optionally, the 5V power adapter can be plugged

directly to the bottom of the MX-890.

Resetting the MX-890

Normally, resetting the MX-890 is not necessary. However, if you

notice unusual behavior, press the reset button within the battery

compartment. Press the Reset button to cycle the MX-890’s power

and reboot the unit.

Page 3

Red indicates charging, Blue that

the remote is fully charged.

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

No comments

Universal Remote MX-890 Owner's Manual Page 6